There is special white stuff for PVC. Normal putty will make joint stuck
forever and pieces can get into pump.


"Steve" wrote in message
...
Putting a pool filter together. When done with the teflon tape, about 8-10
windings, I get slight leaks where the PVC fitting threads into the valve
housing also where the PVC threads into the pump. A hose came off and the
pool drained to the skimmer level so I'm going to disasemble and redo the
fittings.
I bought plumbers putty thinking it may work better???
The guy at the store said to roll it into a snake and wrap around the
threads. I didnt like that method so I worked it into the threads all
around
both the male and female threads. I assembled one fitting and pulled out
the
putty that was forced out while threading the peices together.

I have a couple of joints to go but was hoping for some expert advice on
the
proper/best way to make a water tight connection. I wont know if it leaks
untill I fill the pool to the proper level and turn on the pump. Then its
to
late (or at least a pain) to fix.


Thanks for any advice!!!

Steve