Must cut 40mm hole in 1/4" aluminum bar
Michael Terrell wrote:
I've cut them with a fly cutter.
I have a relatively big arm type hole cutter but it won't cut down
to 40mm diameter. The small one probably wouldn't do unless (maybe)
if all edges were extremely sharp.
I already ordered a cheap tungsten carbide tooth (TCT) hole cutter.
Might try that. Using a hole saw after cutting teeth out of it did not
produce a
clean cut. If that is tried again, only two teeth will remain.
For a lower, variable speed drill press, I might chop up my cheap
drill press
and chuck/attach a powerful cordless drill to the spindle on top.
Will see how difficult, attaching the drill to the spindle and
securing it in place.
Instead of trying to make a 40mm bearing housing, another
possibility here is to work with the inner/shaft diameter of 17mm. I
ordered a couple of (pillow block?) bearing holders (UFL003).
Lots of possibilities now.
--
Thanks to the replies.
|