On 15/01/2020 11:18, GB wrote:
On 15/01/2020 00:01, Steve Walker wrote:
On 14/01/2020 21:05, GB wrote:
I have put up some cement board for a new shower. Some photos he
https://ibb.co/album/k68k5a

The cement board is pretty straight and vertical. The rest of the
bathroom is not!

I am wondering how best to finish off the end of the cement board,
next to the door architrave? I could just squirt some expanding foam
into the gap, but that still leaves the edge of the cement board
exposed.

One possibility is to rout a big groove in a length of timber and
slot that over the end. I was thinking of tiling it first, then the
wood can go over the edge of the whole lot.

That'd probably be a good solution.

Any suggestions most welcome, please.

Fill it and tile around the corner?

I think that would be difficult. It's a small fiddly area to tile. I
could see them getting damaged easily.
Then use care body filler instead of tile cement and buy a tile saw.
Honestly!


SteveW




--
"It is an established fact to 97% confidence limits that left wing
conspirators see right wing conspiracies everywhere"