knuttle writes:
On 1/8/2020 5:05 PM, Unquestionably Confused wrote:
On 1/8/2020 3:31 PM, knuttle wrote:
I have an older table top bandsaw that I have used for some time.=C2=A0=

If you ARE at least scoring the workpiece with the bandsaw with the=20
existing wood blade, go ahead in install and tension the new blade.=C2=A0=
The=20
old blade may be ruined and you forgot about it or the previous owner=20
(if there was one) did it and you just don't know of the particular=20
problem.
=20
Keep us all posted.=C2=A0 It's an interesting problem.

I have several small pieces that are left overs from a picture frame.=20
When I start cutting from the pointed end of the miter, the saw cuts=20
into the wood it reaches a point and then will go no further. The blade=20
seems to be moving.

Sounds like the stock is catching on the end of the insert. Check
to ensure it is flush to the table.