On Sat, 14 Dec 2019 14:08:07 -0000, Terry Casey
wrote:

In article ,
says...


I would have disabled the inner sensor temporarily by unscrewing the
terminal block output wire, but I had nothing that would turn the
deep-set screw.

So after using all that foil you wre still foiled in the end!

Didn't you think to plug the gap round the door with toilet
paper? I'm sure you could have scrounged some sticky tape (or
plaster!) to hold it in place when the door was opened!

If you meant plug the gap to stop the light, I didn't have anything
suitable. I had already looked through all the drawers in the 'Crafts
Room' - not even sticky tape - the foil was kindly brought in by a
visitor and I held it in place with blue-tack borrowed from the
cleaners tick-sheet. The door opens both ways so nothing round the
edge to stop the light. I felt like a prisoner of war.
--
Dave W