Pull saw blades
On 19/11/2019 23:40, Mark wrote:
AJH wrote:
On 19/11/2019 16:47, Mark wrote:
"GB" wrote in message
...
We have a Draper pull saw, and the blade is now blunt.
and I'm on a mission to save the
planet!
Why dont you try sharpening it
Even I wouldn't bother sharpening a blade that costs less than seven
quid, I do sharpen Silky blades as they can be over £60 and I use a
cheap diamond feather edge file.
AJH
and i just like making thinks work again rather then throwing them in the bin
-
Fine, so do I but that one is not one I would do.
If the OP wants to try it then as I said he will need a diamond file as
these saws are induction hardened. The hardening is not very deep so you
cannot do much.
Many moons ago I enquired here about DIY induction hardening and got
some pointers to cheap MOSFET devices but decided against building one
because I doubted I could control the uniformity as I pulled the teeh
through the heating zone.
AJH
|