Table Saw Fence Problems
"Steve" wrote in message
.. .
Stephen Williams wrote:
I have just purchased a Wickes 1500 table saw (very similar to the
equivalent Draper model) and have used it extensively over the holidays.
I have mastered right angle and mitre cuts, I have built a crosscutting
sled
for sheet materials BUT I can't seem to set the fence accurately.
Any ideas how to do it?
There are usually some grubscrews that work against a bolt somwhere near
the handle.
Steve
Thanks Steve
No grub screws just a lever that exerts pressure at both ends of the fence.
When pushing the lever down the fence tends to move out of position.
Steve
|