|
Posted to uk.d-i-y
|
|
|
solder
On Sat, 14 Sep 2019 15:34:49 -0700 (PDT), wrote:
On Saturday, 14 September 2019 22:07:26 UTC+1, AJH wrote:
On 13/09/2019 14:32, Dave Plowman (News) wrote:
In article ,
Nick Odell wrote:
On 13/09/2019 13:15, AJH wrote:
I need to solder a patch onto a rusty diesel tank, previously I used
60/40 tin lead solder but this is not readily available locally will a
lead free plumber's solder still wet fluxed steel?
I don't know the answer to your question but, if you have a Toolstation
nearby, their product 81552 might (expensively) meet your 60/40 spec.
Think most plumber's merchants still stock leaded. For non potable use.
That turned out to be the solution, small plumbers merchant down the
road, actually the nearest shop had a 1/2 kilo roll under the counter.
Once I had wire brushed the rust off there were 3 small holes I could
just put a sewing needle through, Baker's No3 flux and they were easily
wetted and filled, so far a bit less than successful in floating a cover
plate over the lot, not that that's really necessary with a thick layer
of solder.
In the past I would have simply brazed without cleaning the rust as the
flux and acetylene flame work at red heat but I gave up my oxy-acetylene
when I retired, I have been tempted to try TIG with braze but I haven't
pursued it as I seemed to use too much argon.
AJH
Gasless wire MIG is a joy to use. I 'grew up' on arc & to a lesser extent oxy.
I always wondered if one could use CO2 or even flame fumes in lieu of argon, I presume not.
Leaded solder is still used in electronics, just less so. Handy for large non-potable plumbing joints that are a pain to heat.
NT
Any experience of Aldi/ Lidle el Cheapo welders?
I have a couple and tried to use one a few months back with zero
success.
Not sure if what I was trying to do was practical i.e replage a
damaged M5 threaded rod on a stove glass holding clip.
AB
|