DIYbanter - View Single Post

Bob La Londe[_7_]

On 8/17/2019 6:47 AM, wrote:
I need to find schrader valves for a project. Straight, nickel plated.

Are these valves normally brass? Would silver solder be appropriate
for handling 175-200 psi air?

thanks

gary

Depends on the application. You can get them in all kinds of
configurations. Most use a rubber seal of some kind. I think I have a
bag on my parts board with some that that have an NPTF thread instead of
a rubber seal.

McMaster is a good source, but if its a test or throw away application
look on places like Ebay too.