Cutting into a tennis ball
On 7/20/2019 7:01 PM, wrote:
On 7/20/19 6:40 PM, dpb wrote:
On 7/20/2019 4:44 PM, wrote:
Need to cut an 1.5" X into 96 tennis balls. (To attach to classroom
chair legs, if you must know ;-)
So far, a box cutter is not getting it done, neither a small
"cutting" wheel from a dremel kit
Best so far is with ball held in a vise, and using a miter box saw to
cut 2 1.5" slits in ball to form X. But this is a bit tedious for 96
x 2 cuts.
Thought of a table saw, but fingers would be too close to blade for
my comfort
Tried looking for a dremel type cutter that would go in a drill
motor, but haven't seen anything I want to pay for if it does not
work any better than miter saw.
Any suggestions ??
Know anybody with a bandsaw?
--
I think the school has one, but would still be concerned about fingers.
Probably the safest way if done right. You use a push stick behind it.
Safer that a hand held knife.
Guide and push stick, safe and fast.
|