View Single Post
  #6   Report Post  
Posted to uk.d-i-y
Brian Reay[_6_] Brian Reay[_6_] is offline
external usenet poster
 
Posts: 1,508
Default Clearing a blocked car screen wash jet

Graeme wrote:

Unbelievably, just discovered, four years after buying a car, that the
rear screen has a washer as well as wiper :-)

Problem is, the jet, which angles the water 90 degrees, is blocked.
Managed to clear a hole with a needle and very fine drill in pin vice,
but not enough to allow a jet of water through. A small drop comes
through, but nothing more. Unlikely to be scale as such, as this is a
very soft water area. Any thoughts on what I could soak the jet in, to
help? Put through the dishwasher last night, which softened the crud,
and currently sitting in a cup of hot water with a dash of washing
powder. Vinegar, perhaps?


Check the pipe isnt €˜nipped somewhere. I had a CRV an one of the (front)
jets was prone to not working- the only fault I recall having with the car.
The pipe tended to move and wedge itself under the plastic trim bit,
restricting the flow. Eventually I managed to secure it so it didnt move.

Also, our Smart rear jet didnt work. A joint in the pipe run had come
adrift - fortunately it was accessible.

If you are sure it is the jet, replacements arent expensive- many are
fairly generic. Try Halfords.

--
Corbyn & the EU, the Nazis next step: "Our aim was Europe a nation. Our
faith European Socialism" Mosley "My Life" autobiography 1957.