Thread
:
Yaesu FRG-7700 Tuning dial mechanical fault
View Single Post
#
3
Posted to sci.electronics.repair
Cursitor Doom[_4_]
external usenet poster
Posts: 2,783
Yaesu FRG-7700 Tuning dial mechanical fault
On Mon, 10 Jun 2019 05:32:13 -0700,
wrote:
If it is mechanical, it may be jammed on something caught in the gears,
or perhaps the gears have slipped. Otherwise, you may need to replace
the part.
If the main bearing is badly worn, then those teeth can come out of mesh.
I've had this with a Trio TS530s. It's a simple matter to reset the
gears, but if the worn bearing isn't dealt with beforehand it'll come out
of mesh again pretty quickly.
--
This message may be freely reproduced without limit or charge only via
the Usenet protocol. Reproduction in whole or part through other
protocols, whether for profit or not, is conditional upon a charge of
GBP10.00 per reproduction. Publication in this manner via non-Usenet
protocols constitutes acceptance of this condition.
Reply With Quote
Cursitor Doom[_4_]
View Public Profile
Find all posts by Cursitor Doom[_4_]