"Bob La Londe" wrote in message
...
On 5/25/2019 10:25 PM, Larry Jaques wrote: On Wed, 22 May 2019
14:11:28 -0700, Bob La Londe
wrote:

On 5/22/2019 9:49 AM, Leon Fisk wrote:

Do you have enough material to just drill a bigger hole, thread
and use
a larger set screw?

I don't know how hard the tool holder is, but that's not a bad
option.

Gonna do them all/both, so it doesn't happen again? Good man.

--
If more sane people were armed,
crazy people would get off fewer shots.
Support the 2nd Amendment


Actually I want a TC tapper or three for this mill. I am seriously
considering using a 1/2 shank ER collet chuck to make a first one
out of this tool holder. The the set screw becomes mute as there
will be a "slot" for the anti twist pin in the straight shank collet
chuck. I've already made a couple TC tappers that way for my TTS
style tool holder mill out of 1144 so my only concern becomes the
hardness of this tool holder and how to hold it in the lathe.
Probably with an expanding mandrel.

I confused TTS with TTC lathe toolholders.