Hinges
On 20/05/2019 10:08, Graeme wrote:
Looking for a particular type of hinge, but frustrated because I don't
know the proper name.
For a lifting flap, but the pivot needs to be half inch or so above the
flap surface, if that makes sense.Â* Hinge fixing surface is horizontal,
then bends 90 degrees to vertical, to the pivot, then back down 90
degrees to horizontal again.Â* Any thoughts?
parliament hinge?
--
djc
(–€Ì¿Ä¹Ì¯–€Ì¿ Ì¿)
No low-hanging fruit, just a lot of small berries up a tall tree.
|