On 20/05/2019 10:08, Graeme wrote:

Looking for a particular type of hinge, but frustrated because I don't
know the proper name.

For a lifting flap, but the pivot needs to be half inch or so above the
flap surface, if that makes sense.Â* Hinge fixing surface is horizontal,
then bends 90 degrees to vertical, to the pivot, then back down 90
degrees to horizontal again.Â* Any thoughts?


Old hardware catalogues used to have something called iirc bar-top
hinges, for the kind of thing Del-boy fell through. The pivot ½" proud
though? that would be wierd.

TW