On 29/04/2019 17:46, Jim GM4DHJ ... wrote:
On 29/04/2019 13:00, Jim GM4DHJ ... wrote:
On 29/04/2019 11:43, Harry Bloomfield wrote:
formulated the question :
Is the OP talking about shoving the brake piston back into its
housing, as one might do when changing pads? I've always just
levered them, rather than using special tools. I wasn't aware that
they should rotate in a particular direction as they move.

This is the type which combine handbrake as part of the pad/disc
brake, they auto screw out in use as they wear, so need to be
manually screwed back to change the pads.
wish me luck got the pads this morning....first time using the wind
back kit,,,wish me luck...tee hee

that was easy loads of money saved..just wish I hadn't then reversed the
car into the concrete bollard......nothing to do with the brakes .....

just the front to do now they have two pistons .......

--
Report a bad lying Freemason to Mr Baker of UGLE Audi Vide Tace