On 24/04/2019 21:26, Chris Green wrote:

I want something that will enable me to cut accurate right-angled
cross cuts and parallel rip cuts. 'Accurate' means to something less
than 1mm along a long rip cut and properly square for cross. My
WolfCraft table isn't this accurate unless you are very careful and
help it somewhat!

I don't want to spend a lot (hence looking at the Screwfix Titan) but
on the other hand I don't want to waste my money on something that
won't do what I need. Somewhere around the £200 mark is probably my
upper limit. If I'm not going to get what I want at that sort of
level then I'll muddle on with what I've got.

Recommendations please!

Reading between the lines, it sounds like you are after a contractors
style table saw rather than a full sized one. (although if you have
space for a full sized one, a second hand pro level machine from ebay
etc might be a better bet).

Of the cheaper contractors saws, the lower end Charnwood often gets a
mention:

https://www.charnwood.net/products/table-saw

The cross cutting performance with the included mitre guides can often
be a bit suspect on smaller saws, however so long as you can get the
blade parallel to the guide slots in the table, then its easy to make a
cross cut sledge that will give repeatable accurate cuts.



--
Cheers,

John.

/================================================== ===============\
| Internode Ltd - http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/