Sounds like one of the amps may be a little unstable or on the other hand
its a psu issue of some kind where the hum is being picked up from somewhere
else that generates the frequency.
I think I'd try the old one of attaching a length of wire to bits of the
circuit like a speaker terminal, or the earth or another obvious place if
its affected by proximity, sounds more like a parasitic oscillation of some
sort.
Brian

--
----- --
This newsgroup posting comes to you directly from...
The Sofa of Brian Gaff...

Blind user, so no pictures please
Note this Signature is meaningless.!
"Dave Plowman (News)" wrote in message
...
Three way speaker driven by three power amplifiers all balanced input.
Crossover Behringer CX3400 analogue type which sounded not bad at all.

Wanting to experiment further, got a Behringer DCX2496 which is a direct
substitute, but digital, so allows a choice of crossover curves, delays to
each unit, and EQ too.

First impression, setting it to the same as the analogue one, was no
audible difference, which is good.

But slowly, when left on, it developed a buzz from the speaker(s) Loud
enough to be annoying.

Approach the speaker and the buzz drops in level and get close enough and
it goes. So you can play it with a hand rather like a Theramin. ;-)

Thinking it faulty, got another. Same thing. Swapped back to the analogue
one - fine.

Mains grounds and XLR grounds all check out OK.

Difficult to tell if the buzz is from all three speaker units, as when you
get your ear close enough to each one, it stops.

If you power up with no signal, no buzz (at least for over an hour). With
signal, it starts after a few minutes.

Any educated guesses? I've never come across anything like this before.

--
*I never drink anything stronger than gin before breakfast *

Dave Plowman London SW
To e-mail, change noise into sound.