"Tim+" wrote in message
...
Jac Brown wrote:
Got one of these
https://www.dropbox.com/s/0mcpg949t9..._2208.JPG?dl=0
with a badly damaged philips screw head which I can't get out of here.
https://youtu.be/XlYNf101RJ0?t=56
The thing is entirely plastic in two parts. I don't care about wrecking
the
whole screw and what it goes into because I am happy to replace it.
I'd normally just grab the head with some mole grips etc but
cant get the screw unscrewed enough to get a grip on the head,
No easy access to cut a slot in the head and use a flat screw driver.
Guess it might be feasible with a dremel with a cutting disk. I have
both.
My initial thought was a screw extractor/easy out but the don't really
go small enough. The threaded part is only 5.5mm thick. The smallest
screw extractor is listed as 3mm which might well work with a hole
drilled into where the philips slots used to be.
The other possibility is to glue a plastic rod to the head but I don't
have a rod of the same plastic and there is no obvious way to work
out what the plastic is to order a rod of the same plastic and glue.
Is one particular type of plastic normally used on those things ?
I guess superglue and metal rod might work.
Any other alternative I might be having a brain fart about before
I order the smallest screw extractor ?
Not urgent, there is some problem with the windscreen washer
bottle that means it holds very little water but its fine to do
without a washer for a month or two while the extractor arrives.
I would bother with a screw extractor. Id just drill out the middle and
then the whole thing should just pull out.
Yeah, thanks for that, thats what I meant about brain farts.