On Sunday, February 17, 2019 at 7:50:50 PM UTC-5, Michael wrote:
On Sunday, February 17, 2019 at 5:00:55 PM UTC-6, DerbyDad03 wrote:
I finished my daughter's bench. It's a good thing that I don't do this
stuff for a living. My hourly rate would be in the negative numbers.

It's ready for delivery and ultimately to be painted. Painting it is her
choice. She's going to match her already painted dining room table and
chairs. Although painting it would not be my first choice, it's her bench
so I didn't say a word.

This was my first project made from over-sized S2S wood. First use of my
planer. A jointer would have helped. Instead, I made a edge jointer jig for
my table saw fence. It works fine for short boards, but it's tough to joint
a 8/4 x 10 x 6' board, especially in my small shop.

I used three 8/4 x 8' poplar boards, one of which was twisted as some of
you may recall from my "Is My Planer Set Up Correctly" thread. Probably not
the best choice for first-time planer use but I managed.

The design is essentially 100% my daughter's. I offered her options
(straight legs or angled, flat seat or grooved, location of stretcher,
etc.) The result was based on her choices.

60"L x 14"W x 18"H

Comments, questions and concerns most assuredly welcome.

https://i.imgur.com/Ju4XAWW.jpg

https://i.imgur.com/lKWXiTy.jpg

https://i.imgur.com/Ofie3zU.jpg

https://i.imgur.com/49h33u2.jpg

Looks terrific! Nicely done.

Thanks!