On 26/01/2019 19:36, ss wrote:
Re previous post:
Ok having looked at it more carefully I have managed to seperate the 2
parts (also better images below) It is off a Kirby vacuum shampoo water
tank, it is an on/off `valve`
My thoughts are to insert a couple of pins (dovetail layout) to support
whatever epoxy will stick to the plastic and fill the void at the bottom
left hand image.
There is no reason to have to disassemble this part later on so a
permanent fix I am hoping for.

Any further thoughts welcome?

https://imgur.com/a/IlPyXtY
Ah.

NOW I see what is going on.

Is the shaht solid? If it is here is what I would do.

Remove the other lug.

Fill the entire top of the knob with car body filler.

When set drill through it and into the plastic shaft of the other bit
and put a couple of small self taps in.




--
"If you dont read the news paper, you are un-informed. If you read the
news paper, you are mis-informed."

Mark Twain