"Matthew" wrote in message . net...
--
I live on Long Island and own a colonial home with a second floor attic and
partial roof over my 1st floor den and kitchen off of the rear of the house.
My upstairs attic is well ventilated and is insulated with attic blankets.
The issue is with my lower roof. It is a sealed design....no gable vents (I
suppose there are no true "gables" per se...the roof comes off of the rear
of the house). That attic not being ventilated, the insulation is relatively
minimal. I never had a problem until I has vinyl siding installed a few
years ago. The siding itself was installed over "super tuff-R". Only
recently while having some electrical work done did I realize that the
contractor cut huge holes in the original plywood soffit before installing
the ventilated vinyl soffit. My den and kitchen have been notably cooler in
the winter and I can now safely assume it is coming from these previously
sealed, now vented soffits. I have no roof vents or gable vents so there is
nowhere for the air that enters the soffits to go but DOWN, not out.

Now the question.....
I have no access to this attic short of cutting a HOLE in the side of my
house to get in there to insulate. I will not have blown insulation
installed...I don't like the stuff. I know it may not be "proper" but can I
just pull down the vinyl soffit, stuff insulation into these huge holes and
replace the vinyl?? I will sort of put it back "the way it was".

All suggestions appreciated!!!
Thanks,
Matthew

You will neeed more than insulation to effectively close those holes.
Since the holes are most likely not square, this should work. Try
cutting plywood a bit larger than the hole, slide it up through the
hole and position it to cover the hole. Construction adhesive should
be enough to seal the perimeter.
TB