It sounds awful cheap, but what I call 'bacon plastic' (like bacon comes
on), is the best shield in the world.
It's designed to shed grease, and wipes off easily, nice and large enough to
hold.

Tim S.

"hollywood_steve" wrote in message
om...
Greetings,

I have just rented a small (one room) office for a hobby that has
grown into an obsession. The office has a 2x2 suspended ceiling with
the cheapest type of grid and tiles (the tiles lay flat on top of the
grid, there is no "reveal" or cut-away at the edge of the tiles). But
none of this really matters.

I will be painting the four walls tomorrow; they are all typical
gyp-board walls with many layers of paint on them already. Although
its probably been ten years since I've held a brush or roller, I have
painted a few dozen rooms in my time, but I've never painted a room
with a suspended ceiling.

I'm guessing that the best way to proceed is to trim along the ceiling
and floor and then come back with the roller and fill in the remaining
95% of the wall. But what is the smartest way to trim in against the
ceiling grid where it runs along the walls? Should I just use a
medium sized brush and go slowly, or is there some type of "edging"
tool that will roll along the grid and leave a consistent paint edge
just short of the grid? I did my semi-pro painting back in college
and I gotta believe that there are some new handy-dandy products from
Ronco that didn't exist back in the late 70's. What are they and
which one should I use to avoid getting paint on the ceiling?

Thank you.

Steve