I used coolant and it was mostly OK, you place some lexan screens
strategically and it is tolerable.,

i

On 2018-11-25, Bob La Londe wrote:
Who uses flood coolant on their manual lathe?

Do you get sprayed when using it? Do you waste a lot of coolant.

I was turning some 304 stainless yesterday on the 1440 and everything was
going fine until it started to get hot. Then it cooked inserts, and fast.

If you run flood do you stop using insert tooling?

Until now I've just used a cutting oil on the lathe when the cut seemed to
act like it needed it.