I ran the clean cycle on our Cuisinart DCC-2650 coffee maker, but then
when I went to rinse it with clean water it didn't heat up.

I removed the screws from the metal bottom plate, but it seems that that
was a mistake, because when I removed the deep-set screws in the plastic
part of the bottom and removed the whole bottom everything was
disconnected from that metal plate, and I can't see exactly where
everything fitted.

More precisely: there is a Q8025J6 Triac hanging by its wire leads,
which are held against the edge of a clear plastic part, and an aluminum
plate (heat sink) but I can't figure out exactly how they go back together.

And IAC if the Triac is the problem, so far I've only found companies
selling them in minimum lots of 50.

Perce