On Wed, 19 Sep 2018 16:40:30 -0700, wrote:

I have a small run of parts that have a #3 Morse taper on one end. At
the small end of the taper is a straight diameter that's .700 diameter
by .600 long. The material is 17-4 PH stainless. I want to harden the
small end only. To do this it must be heated to 900 degrees F and held
there for a while. I was wondering if a 2000 watt induction heater
would be up to the task. I know there are many variables but there
must be a minimum amount of power needed. Anybody know?
Thanks,
Eric

Why not simply stick em into a broiler?

__

"Poor widdle Wudy...mentally ill, lies constantly, doesnt know who he is, or even what gender "he" is.

No more pathetic creature has ever walked the earth. But...he is locked into a mental hospital for the safety of the public.

Which is a very good thing."

Asun rauhassa, valmistaudun sotaan.


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus