On Sat, 15 Sep 2018 17:56:18 +0100, John Rumm wrote:

That seemed to be a response after testing lots of cheap chinesium
extension leads and finding that under high loads they would fail
catastrophically. The 10A fuse will still likely carry 13A indefinitely,
but will limit the scope for overloading as far as a 13A fuse would
permit.

We only found out about the 10A fuse when I got some wallah around to do
a bit of welding. Since this was very light gauge stuff which I can't be
doing with, I got this specialist bloke in. He'd been using it on and off
for about 4 hours before the fuse in the reel finally gave up the ghost.
Poor bugger had been cussing about not being able to strike up as
smoothly as he usually could so it looks like his MIG was being current-
starved by a fuse that was 3A less than it should have been for that load.
Had it not been for that incident, I'd most likely never have known!



--
This message may be freely reproduced without limit or charge only via
the Usenet protocol. Reproduction in whole or part through other
protocols, whether for profit or not, is conditional upon a charge of
GBP10.00 per reproduction. Publication in this manner via non-Usenet
protocols constitutes acceptance of this condition.