Nominal thread size
On 9/3/2018 8:37 PM, DoN. Nichols wrote:
On 2018-09-03, Terry Coombs wrote:
On 9/2/2018 7:17 PM, DoN. Nichols wrote:
Also -- you need a different feed in for the toolpost at 20
degrees (or 19-1/2 degrees) than for feeding in square.
Good Luck,
DoN.
Â* Are you sure , or is that a mistype ? I feed at 29.5° on the compound
, with the cross feed zeroed so I can return to the same pointÂ* - feed
is done with the compound .
A mistype --- the 29-1/2 degrees is what I intended, or 30
degrees.
Sorry,
DoN.
Â* I figgered as much , you've been around too long to make that kind of
mistake .
--
Snag
Yes , I'm old
and crochety .
Get off my lawn !
|