On 2018-09-03, Terry Coombs wrote:
On 9/2/2018 7:17 PM, DoN. Nichols wrote:
Also -- you need a different feed in for the toolpost at 20
degrees (or 19-1/2 degrees) than for feeding in square.


Good Luck,
DoN.

* Are you sure , or is that a mistype ? I feed at 29.5° on the compound
, with the cross feed zeroed so I can return to the same point* - feed
is done with the compound .

A mistype --- the 29-1/2 degrees is what I intended, or 30
degrees.

Sorry,
DoN.

--
Remove oil spill source from e-mail
Email: | (KV4PH) Voice (all times): (703) 938-4564
(too) near Washington D.C. | http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---