Before you get all involved here, I would just pick it up at the front a few
inches off the ground and let it go. The shock when it hits the ground
might just clear up whatever is stuck or out of place and causing the
beeping.
Worth a try and probably won't do any damage.
Des

"Kumar" wrote in message
om...
Beeping does not stop (the beep sounds like when you push the
buttons). There is no pattern to the beeping. When I unplug the
machine, the beeping seems to go away for a bit, but then returns
after plugging back in and choosing a cycle. Dryer heater and tumbler
are STILL ON when this is occuring. I have cleaned the sensor with
alcohol, I have also cleaned the entire lint trap system to make sure
there were no clogs. Also, it won't allow me to go out of "Cotton
High Heat" mode now. It won't let me "stop/cancel". I can only
change "modes" when i unplug the unit and plug it back in. This is
driving my wife and me nutz...anyone know if this is known issue or
any other groups I can post this issue to? I'm fairly technical, so
if it needs new parts, I can probably change.

thanks in advance!

Kumar.