Tim+ Wrote in message:
https://photos.app.goo.gl/Rt6Ju7hN7rkF8ip29

Is it possible in this door?

I'm wondering about a reduced length window in the centre section
and if possible, a new crosspiece to enable secure glazing and
place to put a cat flap. Is this possible post-manufacture?

Tim

Technically I expect it's possible, given the correct uPVC profile
& associated window /door manufacturing equipment.

Practically I'd be surprised if anyone would take it on. Plus it
would most likely mean the door having to be removed & taken away
to do it "properly".

Can you find a catflap to suit the width anyway?

You might be able to fit one neatly in the lowest part of the
panel, then fit a shorter DG unit above it. The trickiest part
would, I think, be either transferring the weight of the DG unit
down to the bottom where the original DG unit now sits, or making
alternative arrangements...

If there is enough meat on the catflap bezels, you might be able
to hide a bit of ally? angle behind them, rivetted? to the sides
of the glazing rebate, & sit a suitably sized new DG unit in
that?
--
--
Jim K


----Android NewsGroup Reader----
http://usenet.sinaapp.com/