On 13/06/18 09:22, newshound wrote:
On 12/06/2018 20:30, wrote:
Hi all

I have taken some photos and tried to upload them to a public album
(hopefully not done this for ages). They show the fittings and
particularly the brass fitting I need to connect the sheath to.
Hopefully this works

https://photos.app.goo.gl/L44RinHPY2v2UeEbA

I have tried some searching but can only find examples of soldering
the fitting to the wire rather than the sheath to the fitting.Â* They
seemed to use "silver solder" which I assume is not the same as
plumbing solder

Thanks

Lee.

Very helpful. "Silver soldering" is done at red heat, I think even "soft
soldering" (i.e. plumbing / electrical) will deform the plastic however
careful you are. I would go for epoxy: abrade and degrease the parts
first. Someone has already suggested this.

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus

Silver soldreing is done at a bit less than red heat, but yes, its way
above 'soft solder'


--
"And if the blind lead the blind, both shall fall into the ditch".

Gospel of St. Mathew 15:14