On Sun, 27 May 2018 21:24:46 -0700, Bill Wright wrote:

On Sunday, 27 May 2018 22:52:26 UTC+1, Tim Lamb wrote:

Can't you find a fabricator near you.

Well, I'm doing bits and pieces all the time. A lot of vehicle body
stuff at the moment.

Bill

Then you will only rarely want anything as thick as 2mm for structural
chassis box sections, outriggers and stuff. Most car panelwork like wings
& doors is sub 1mm.



--
This message may be freely reproduced without limit or charge only via
the Usenet protocol. Reproduction in whole or part through other
protocols, whether for profit or not, is conditional upon a charge of
GBP10.00 per reproduction. Publication in this manner via non-Usenet
protocols constitutes acceptance of this condition.