On Thu, 26 Apr 2018 05:18:18 +0100, Clare Snyder wrote:

On Wed, 25 Apr 2018 20:51:19 -0600, rbowman
wrote:

On 04/25/2018 11:51 AM, Jimmy Wilkinson Knife wrote:
On Tue, 24 Apr 2018 04:08:51 +0100, Bob wrote:

On 4/23/2018 11:18 AM, Clare Snyder wrote:
One sepentine belt and tensioner -$150

Obviously you do your own repairs. Good for you but if you don't have
your own shop and a decent set of tools, the economics change
drastically.

Back when I used to have one of those ****ing engines that would
self-destruct when the timing belt broke, the cost to replace the belt
(parts and labor) was very near $900...and I could never find a
competent shop to do it cheaper. And the damn belts
had to be changed every 60,000 miles.

Are you saying snapped timing belts is no longer a problem? I thought
most modern engines hated a snapped belt (they're called "interference
engines").

My engine doesn't have a belt.


More and more are going to chains again, and non-interference
engines are also becoming more common.

Chains don't last forever either - I used to change quite a few
timing chains on inline 6 and V8 engines - and LONG before 100,000
miles. Quite a few before 60,000

Mitsubishi 2600 4 cyls (used by Chrysler for years) had 0ver 6 feet
of chain in them and they were notorious for dropping the chain that
drove the balance shafts and the oil pump - letting the engine
continue to run with no oil pressure and self destruct.

Anything that can break an engine (including overheating which none seem to have protection for) should cut the fuel immediately with a sensor. Basic obvious design. How stupid are people who design cars?

--
My neighbour asked if he could use my lawnmower. I told him of course he could, so long as he didn't take it out of my garden. -- Eric Morecambe