On Wed, 04 Apr 2018 14:20:31 -0700, Larry Jaques
wrote:

On Mon, 02 Apr 2018 18:14:45 -0700, Gunner Asch
wrote:

On Mon, 02 Apr 2018 13:41:13 -0700, Larry Jaques
wrote:

On Mon, 02 Apr 2018 00:59:01 -0700, Gunner Asch
wrote:

I picked this up some 7 or so years ago..and its been sitting in a
corner ever since. Broken table has been repaired properly. It needs
to be reassembled and tested. Might need a bit of turcite under the
slide..maybe not.

Its available in Chino, California, for the next couple weeks. After
that..I haul it up north and put it into my shop. I really have zero
need for it..its small, but would make a wonderful little hobbyist
mill or gunsmith mill

https://goo.gl/photos/d5yTPXMeM8tvZSrf7

3-phase? What HP? I've been wanting a mini-mill forever.
That looks heavier-duty than a HF mill.

3ph yes. about 1hp. I dont recall if its metric or .001

Ive got collets and other tooling for it. You will likely have to
find a vise unless I have one kicking around. About a 4" would be
appropriate.

Its a Makino. And Makino claims tney never made it. (Grin)

Is it because it doesn't have much depth to it, or the Seiki half of
it? Or were they beasts to keep running?


You already have this little Yamazon Horizontal/Vertical mill still
sitting here. I gave it to you about 4 yrs ago. You were supposed to
come and get it.

https://photos.app.goo.gl/TjRIutKOdOonL02I3

blink,blink You did? Why didn't you tell me?
More info, please. Google doesn't have a single hit.

When you came to the house..I offered it to you. You couldnt load it
because you were going someplace after leaving my house..but you would
pick it up the next trip down.

I gave away the Makino this week..but the Hales/Yamazon is still
available to you.

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus