On 3/18/18 9:55 PM, Jerry Osage wrote:
On Sat, 17 Mar 2018 17:34:36 -0500, -MIKE-
wrote:
On 3/17/18 2:11 PM, Tim Daneliuk wrote:
On 03/17/2018 02:07 PM, -MIKE- wrote:
fÂ*he'sÂ*aÂ*professionalÂ*framer,Â*thenÂ*he'sÂ*alr eadyÂ*thoughtÂ*ofÂ*myÂ*suggestion.
ItÂ*shouldn'tÂ*takeÂ*twoÂ*framingÂ*carpentersÂ*any Â*longerÂ*toÂ*doÂ*whatÂ*I
describedÂ*thanÂ*itÂ*tookÂ*meÂ*toÂ*typeÂ*it.Â*Â*:-)Â*Â*Â*Â*Seriously.
I dunno about that. You have to take it up, tack it in place, measure,
take it down, cut, remove the top, and install it. That's a lot of steps.
Right. A LOT fewer steps than trying to measure each stud.
You said he was a pro. With an inexperienced helper, it would be done
in an hour, tops. This is something a professional framer would've
figured out by intuition.
I gave you a really good solution to the problem. I'd be setting
trusses by now. :-)
Is this guy a missionary, by chance?
This is starting to sound like a Troll.
Solution presented -- Yes, but...
Another solution presented -- Yes, but...
The guy wants to use a Chop Saw with a Laser Rangefinder and he stated
three questions:
~~~~~~~~~~~~~~~~~~
Questions:
1) Do distance finders allow offsets like that to be dialed in?
2) Is there a better/faster/smarter way to do this?
3) Is there already a tooling system for just this problem?
~~~~~~~~~~~~~~~~~~
It appears that any answer to question 2 is invalid unless it addresses
the Chop Saw and a laser rangefinder.
Seems that way, huh?
I'd have the trusses up by now. :-)
--
-MIKE-
"Playing is not something I do at night, it's my function in life"
--Elvin Jones (1927-2004)
--
www.mikedrums.com