"Rick Hughes" wrote in message ...
Hope someone can help ...

My existing alarm panel (A1 Alarms RF8000) has failed, now bought a

complete replacement RESPONSE RE 3000, I want to use my existing Bellbox,
and not have to install the box which came with the kit .... my house has
been sold and I will be moving out.

To avoid having to replace the bell box, I would like to wire in the

new RESPONSE RE3000 to use the RF8000 bell

box.

However I am confused as to what I connect to what.

The A1 alarm used 6 cores to the bell box :

Colour alarm panel id Bellbox id

Green - 0 -

White - RT Return

Black - Bell - sw -

Red - Bell + +

Blue - Strobe - Strobe

Yellow - Strobe + Strobe



The RESPONSE only uses 4 wires ..

Red - Siren

Black - COM

Yellow - Charge

Blue - Tamper

There are 5 other unused connections - NO, C, NC, Power -, Power +



Anybody know how to connect the existing A1 alarm box up to the

Response



Rick


The Response Sounder doesn't have "Strobe" connections, so you can miss them out.

The negative - from the control panel is connected to the COM

The positive + from the control panel is connected to the Charger

The Tamper is connected to either a positive or negative return in the control panel. You'll have to tell
the panel what the bell box uses in the programming, and find out with a test meter which signal of tamper
in the bell box sends back to the panel.

You'll need a switched connection from the control panel, either positive or negative dependant on which
makes the Siren work, from the control panel to the Siren terminal in the bell box. You might be able to
use the Strobe or Switched Bell connection from the control panel to make this work.

Hope this helps.


---
http://www.basecuritysystems.no-ip.com

Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.553 / Virus Database: 345 - Release Date: 18/12/03