Thread
:
Steel Grind
View Single Post
#
8
Posted to sci.electronics.repair
[email protected]
external usenet poster
Posts: 524
Steel Grind
On Saturday, February 17, 2018 at 5:06:29 PM UTC-5, Ralph Mowery wrote in sci.electronics.repair:
In article ,
says...
On Friday, January 26, 2018 at 2:45:57 PM UTC-5, BenAnd wrote:
Repairing metal housing.
7/8" steel tube with ends slightly rounded inwards.
I need to remove all and a little more of the rounding inwards.
What material bit for either 1/4" OR 1/8" shank hand drill motor or
Dremel is best to use ?
I have many of these to do.
Can you just re-cut the end?
Maybe a step drill bit, or a conical bit.
(A dremel sounds a bit wimpy for the job, unless it's thin walled
SS.)
George H.
Did anyone mention a tapered reamer ? The pipe threading machines
usually
have them built in.
Do they work on rigid? pipe?
Reply With Quote
[email protected]
View Public Profile
Find all posts by
[email protected]