On Tue, 20 Feb 2018 23:32:54 +0000, Michael Chare wrote:

On 20/02/2018 15:46, PeterC wrote:
On Tue, 20 Feb 2018 12:54:32 +0000, Michael Chare wrote:

I need to replace a rotary airer clothes drier. The old one fell down
probably in a strong wind because the bottom of the post had corroded.

The drier is in the middle of a tiled patio. There is a hole in the
middle of the patio which must be about 30cm deep. The old airer had a
metal spike which was about 40cm long, so the top was about 10cm above
ground level. The shaft diameter was about 35mm

I propose to buy a Brabantia Rotary Topspinner 40m. The shaft diameter
is 45mm. There is a metal spike for this drier which is 45cm long, but
if I bought one, how would I make the hole deep enough and maybe a
little larger in diameter? I don't want much of the spike about ground
level. Maybe just enough to be able to pull it out of the ground should
there be a need.

Michael Chare

SDS drill.


How would I get the swarf out of the hole?

Bit of tube (32mm might just go in) on the vac.
--
Peter.
The gods will stay away
whilst religions hold sway