Thread
:
Steel Grind
View Single Post
#
7
Posted to sci.electronics.repair
Ralph Mowery
external usenet poster
Posts: 4,228
Steel Grind
In article ,
says...
On Friday, January 26, 2018 at 2:45:57 PM UTC-5, BenAnd wrote:
Repairing metal housing.
7/8" steel tube with ends slightly rounded inwards.
I need to remove all and a little more of the rounding inwards.
What material bit for either 1/4" OR 1/8" shank hand drill motor or
Dremel is best to use ?
I have many of these to do.
Can you just re-cut the end?
Maybe a step drill bit, or a conical bit.
(A dremel sounds a bit wimpy for the job, unless it's thin walled
SS.)
George H.
Did anyone mention a tapered reamer ? The pipe threading machines
usually have them built in.
Reply With Quote
Ralph Mowery
View Public Profile
Find all posts by Ralph Mowery