Thread
:
Taper of Potentiometers
View Single Post
#
13
Posted to sci.electronics.repair
Ralph Mowery
external usenet poster
Posts: 4,228
Taper of Potentiometers
In article ,
says...
The log pot would always be for volume.
Log pots had a very gradual rate of increase in resistance as you turned it clockwise.
Logarithmic pots were typically used in volume controls for two reasons:
1) The log taper provided a finer control of listening volume at low levels, where users need that fine control, and
2) The log taper provides what is essentially a "dead band" at the low end of the pot, therefore accommodating the installation of an on/off switch on the back of the pot, without sacrificing low level volume control. The switch often requires a 15 or 20 degree rotation in order to activate -- using up part of the pot travel.
Interestingly, some of the aftermarket modular pot/switch manufacturers weren't that great about following those "rules" and when you installed such a replacement switch control into an old radio, the volume at switch activation was already too high for comfortable listening.
I always though the audio taaper was because the way the ear responds to
sound in sort of a log function.
Reply With Quote
Ralph Mowery
View Public Profile
Find all posts by Ralph Mowery