On 1/17/2018 5:55 PM, Michael wrote:
On Friday, December 15, 2017 at 1:31:05 PM UTC-6, Leon wrote:
About 8~9 years ago Bridge City Tools came out with a fine little jig
that enabled you to cut perfect fitting dados with just about any width
blade or router bit. That is as long as the blade or bit cuts narrower
than the width of the dado.

I bought that expensive little jig and have had great success when using it.

Seems there is a shop made version now and probably the absolute
simplest that I have seen.

Take a look!

https://www.youtube.com/watch?v=fNZWlLPw0HI

This is great. I will definitely make one and use it. Thanks!

You are welcome buttttttt......

if you want a simpler one and your set up sample can be easily set on
the saw table top, this one is as easy as it gets. It does involve
repeatedly using your set up sample with each new dado but it does not
get much simpler than a small piece of wood with a screw in the end of it.

https://www.youtube.com/watch?v=x8LpgWEk-O0