On 01/14/2018 02:25 PM, Bob La Londe wrote:
The bad part is I don't know how to remove the new bearings and save them.Â* The obvious way to pull the bearings pulls the rear bearing apart when you take the housing and bearings off the shaft.Â* So... even if I find a good replacement ballscrew I'll wind up having to chase down another set of bearings too.

If you're going to junk the old ballscrew anyway, just machine away enough to let you get the good bearings off.

--
Bob Nichols AT comcast.net I am "RNichols42"