On 1/14/2018 9:11 AM, DerbyDad03 wrote:
On Sunday, January 14, 2018 at 8:12:31 AM UTC-5, dadiOH wrote:
"DerbyDad03" wrote in message
...
I am curious. Are you not able to glue from the table saw rips?
It is my understanding that the best glue-ups come via this process:
1 - Joint one edge to make it perfect straight and square
2 - Rip the board parallel on the TS with the jointed edge against the
fence
3 - Very lightly joint the ripped edge to remove any saw marks.
My table saw leaves a very clean edge, but my router table leaves a edge
that is buttery smooth.
Except for the bumps
I actually added that at the end of my post and then deleted it before
hitting send. :-)
LOL....