jkn wrote:

On Thursday, December 14, 2017 at 11:57:21 PM UTC, Roger Hayter wrote:
snip

Replace the tee with a 28/22/28 tee which should be easy if the nut
threads are the same (the olives will have to come off if not) and put a
slghtly bent bit of 22mm pipe in place of pipe 33. Obviously, slightly
bend a much longer piece and cut to length.


--

Roger Hayter

Yebbut ... that (bent pipe...) will make the join to the tank *lower* than
it is at the moment ... whereas I want it *higher* ...

J^n

Could do either! Depends which way you put the bend. Don't forget
tee can rotate about it's 28mm axis.

--

Roger Hayter