On Wednesday, 29 November 2017 17:06:57 UTC, T i m wrote:
On Wed, 29 Nov 2017 08:50:01 -0800 (PST), whisky-dave
wrote:

On Wednesday, 29 November 2017 16:32:58 UTC, T i m wrote:
On Wed, 29 Nov 2017 13:38:10 +0000, Andy Burns
wrote:

whisky-dave wrote:

What I don't understand is why a 1.3KW heater would be better than a
2KW at giving out heat.

It *might* be better, if. e.g. the 1.3kW can operate at 100% duty cycle,
but the 2kW keeps hitting its overtemp stat and operates on less than a
65% duty cycle.

The other thing that came to mind is that he would probably get more
heat out of the radS with them all on.

what if we ran it at 240V rather than 215V or 202V ?

What do you think?

I think it would make it a pooreer heater due to this cycling you refer to.
If we ran it out a lower votage the duty cycle would increase to a higher percentage which you claim is bester.


would it be better or worse at providing heat. ?

What do you think?

So what is the optimium volage for a 2KW heater ?

What do you think?

I would hope that it is the voltage it has been designed to work on and that is what they call the operational voltage but that of course depends on other factors.


(and potentially maintaining)
the 1300W element than with them all trying to run both (at ~2kW
total) because of the voltage drop from the crap power supply.

So run it at 110V then it is highly unlikely it'll NEVER cut out.

What do you think?

I doubt it would ever reach the point where the overheat protection is applied.


But if it does..
back to the 9V battery so it definanlty won't ever overheat.

What do you think?

it's would depend on the battery whether it could, but I don't believe the heater would ever go into it's 'cycle' as you call it.

I also think that runnin git at about 240V of possible would make it less efficiant than running it at 202V



And with that supply he'll probably be getting as much heat out of the
ring main as he will the heaters themselves. ;-)

didn;t seem to be the case afer a couple of hours.

Like you, it was a joke mate. ;-)

and thr biggest joke is someone claiming that 240V is the correct voltage to apply to a heater that says it's operational voltage is 230V.

I took the tester home last night and I too got a reading of 238-239V
went down to 237-8 when boiling my kettle.
Even the 51Hz went down to 50Hz but then again I don't think such small changes mean much as the unit samples at about twice per second.






Cheers, T i m