On 10/11/2017 21:38, Bert Coules wrote:
Iggy wrote:

Just the basic Gorilla Glue will do the trick.

Thank you.

Surely if it does prove necessary (and practical) to drill through the
laminate it should be possible to plug the holes afterwards with an
appropriately coloured filler of some sort, shouldn't it?Â* Thank you for
the tip about waterproofing those spots.



If the laminate board can be lifted slightly more the hole can be
drilled diagonally starting at the edge and may hidden when fitted flush
again.

Consider injecting the glue using a syringe without a needle (medical or
printer ink replacement from ebay). Some syringes have fairly long
plastic outlet nozzles over which the needle is attached and would allow
a hole of a few mm to be pumped full of glue. Alternative, if the glue
consistency allows, some of the ink refill syringe needles may be of a
wider bore to allow pumping glue down a 1 or 2 mm hole.

--
mailto: news {at} admac {dot] myzen {dot} co {dot} uk