On Thursday, 2 November 2017 16:05:22 UTC, Andrew wrote:
On 01/11/2017 17:03, Andrew wrote:
On 01/11/2017 16:48, Fevric J. Glandules wrote:

Helping someone out with this... their back door has a panel in
the lower half which must be all of 2mm thick.Â* I am thinking
to insulate this in some way but cannot decide on the best
material to use.Â* As "not being ugly" is apparently a consideration.

Any thoughts?


UPVC, Timber or Aluminium ?.

If UPVC, then insulated panels are available but cost more than
a proper DG glass unit.

If aluminium, then there are *loads* of aluminium decor panels
insulated with polypropylene piled up at scrap yards all over
the place.

I bet they don't get resold :/ for low rise housing where they're appropriate.


NT