On Tue, 3 Oct 2017 10:17:29 -0700 (PDT), robobass
wrote:

I bought this thing for around $10 shipped direct from China.
http://i.ebayimg.com/images/g/MYIAAO...zw/s-l1600.jpg
http://www.ebay.de/itm/Nebel-Kuehlmi...72.m2749.l2649
I don't need mist for most stuff, so don't want to spend a lot on it, but it would be nice to have. I have a CNC router with a high speed spindle which holds endmills up to 6mm.
So far I have only tested it with water. It won't siphon up the water at all unless I run the air at very high pressure. If I lift the reservoir above the nozzle then the water flows too freely, even with the air off. I've used mist coolant in the past. The unit I had years ago worked well enough that I never had to fuss with it, and so never learned anything about how it worked. The only thing I can think of now is to keep the reservoir high, but somehow restrict the flow. Any tips, or should I just toss the thing?
Thanks,


Misters like that tend to work pretty well. You either have a
defective one..or you are adjusting it wrong.


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus