"Terry Coombs" wrote in message news
On 8/9/2017 2:20 PM, Leon Fisk wrote:
On Wed, 9 Aug 2017 14:02:47 -0500
Terry Coombs wrote:

I have one that's not feeding well , and wonder if it can - and
should - be cleaned . I have a new one on hand , but it's sized for
.035-.045 wire , and I usually use .025 solid . I have .035 flux core
loaded right now , but that was for an outside job that was blowing my
shield gas away and I'd much prefer to go back to solid - I also have
some .030 on hand but haven't yet tried it .
I've heard of guys doing it but usually it's just for finishing a job,
like on a weekend and no-obtanium till Monday...

I was working on a Miller 250MP last winter for a friend and I could
find replacement liners for ~$12 on Ebay. This was a liner for .024
to .035 wire. The only hard part was identifying the part number
needed. His gun wasn't easily recognizable and had the part numbers
worn off.

I think you should check replacement pricing first, don't think it will
be that much. Probably around $25 or less...

A new liner and drive roller came in the mail today from USAWeld .
Under 30 bucks for both delivered , $9/liner and $14/roller

**********************

I like USA Weld for replacement parts. Usually have atleast one of about
anything in stock and they are always an exact fit.


--

Snag